Monitor and supervise I&C works executed by the EPC contractor and subcontractors. Ensure compliance with project specifications, IEC/ISA standards, and HSE regulations. Review and approve I&C installation and commissioning procedures. Ensure all I&C activities align with project objectives, schedules, and technical requirements. Participate in design reviews, HAZOPs, control philosophy reviews, and FATs. Review I&C engineering deliverables including drawings, instrument datasheets, loop diagrams, I/O lists, and control logic documents. Coordinate with electrical, mechanical, and other engineering disciplines to resolve interface issues. Act as the focal point for I&C technical queries, deviations, and non-conformance issues. Oversee pre-commissioning and commissioning activities including loop checks, instrument calibration, and signal verification. Verify compliance and integration of DCS/SCADA systems with overall plant systems. Maintain accurate records of inspections, site activities, deviations, and resolutions. Prepare weekly progress reports highlighting risks, issues, progress, and achievements. Ensure I&C activities comply with QA/QC requirements and support audits and punch listing. Demonstrate full commitment to HSSE standards and the Incident and Injury Free philosophy. Report hazards, unsafe acts, incidents, or near misses immediately. Correctly use and maintain PPE; follow all HSSE procedures, work instructions, and permit requirements. Attend toolbox talks, HSSE meetings, and required safety trainings.